The commands below will follow the same format if you are connected to a WS-4 /10, EWS-4/10 or a PSKIT-1. Due to the different operational requirements, a WS-x and/or non-emergency PSKIT-1 will not page or reference any emergency zones and a EWS-x or an emergency PSKIT-1 will not reference any normal paging zones.
V – Validate Pin – Unlocks a paging station if PIN access has been enabled
L – Locks the paging station so that a PIN code will be required to access it
Q E - Return details of the Emergency Paging Priority Threshold
Q T Z -Return details of the page Inhibit Priority Threshold
Q L – Return a list of Page Codes that have been assigned to the paging station
Q P – Return the configuration of the specified Page Code
Q Z – Return a list of available zones in a world
Q S – Return the current operating state of the paging station
P – allows the selection of a Page Code from one of those in the configured codes (See ‘Q L’)
Z Z – Specify paging destinations zones using a zone number format.
Z A – Specify that all available paging zones be used as a destination for the next page.
C– Command used to specify a ‘zone page command’ priority, preamble and live or delayed page. (Note: the 'C' command replaces the deprecated 'O' command (pre-1.8).
R C - used to cancel a repeating Page.
R N - specify the number of times a particular announcement will be repeated
R I - used to request infinite playback of announcements. These announcements can only be stopped using the 'R C' command.
R T - specify the time interval in seconds between repetitions for subsequent announcements
@- Relay a specific VTP command to an Emergency Paging Station in the local World